Archiv verlassen und diese Seite im Standarddesign anzeigen : [spark] overclock error
I did set the frequency to 600 MHz.
No, I get an error in the overclock menu. Response is slow. And I can not set clock frequency anymore.
Reset, reboot, switching Off/On doesn't help.
Is there a solution for this? Other than re-install.
can you login via telnet?
make a cat /proc/cpu_frequ/pll0*
and post the result here
Here it is:
SPARK:~# cat /proc/cpu_frequ/pll0*
Modul HZ = 250
CKGA_PLL0_CFG = 80001401
CKGA_PLL1_CFG = 80002803
TMU0_TCOR = 186a0
TMU0_TCNT = 60d7
TMU1_TCOR = ffffffff
TMU1_TCNT = fcd1a45c
TMU2_TCOR = ffffffff
TMU2_TCNT = ffffffff
BOGOMIPS (static)= 597
BOGOMIPS (measured)= 261
PLL0 = 1200 MHZ
SH4 = 600 MHZ
PLL1 = 800 MHZ
HDMU center / frequency control is still showing error.....
mh looks ok
you can make this
killall rcS
killall enigma2
log in via ftp, go to /etc/enigma2/
open settings file and delete the freq line
save
and then init 6 via telnet
Did this.
Still showing error in the Overclock menu.....
then reisntall image, without restore or something and test again
OK. Will do that. I am sure that will help.
After this install it worked, but somehow it lost it.
No luck here.
I did a fresh install of 1128.
Still showing an error at the Overclock menu. Unable to set the clock frequency.
It works now......
I don't know why. I installed a new skin. ValiflexHD. Then I did some changes in settings. I tried the Overclock Control again. And now I could set the frequency again to 600 MHz.
Still don't know what the error caused. Maybe I had to switch it off completly for half an hour....
And now it doesn't work again....
the same error in the overcloc menu.
after i made a few settings in the system menu. went back to the overclock menu, and 'error' again.
Powered by vBulletin® Version 4.2.5 Copyright ©2024 Adduco Digital e.K. und vBulletin Solutions, Inc. Alle Rechte vorbehalten.