problem boot HDMU_12112_E2_1008g+se+_213_git_569

[toufik_d]

I have a 1008g + se + : س
The problem I've ever had and did not know that was caused after Fargo guide me


When you try installing the latest version of the image hdmu device does not boot


So that it stays stuck on the word boot


Is the problem in the bot or take-off in which the loader in the device


Note that the rest of the old photos off a very ordinary


If the problem of Alkornel new image when working pkt : D

[spartak73]

Ja bei mir ist das gleiche. Bleibt stehen. Box bootet nicht. Hier ist Bootlog:


U-Boot 1.3.1 (Nov 15 2013 - 23:53:18) - stm23_0046

DRAM: 256 MiB
NAND: 256 MiB

In: serial
Out: serial
Err: serial
set ethaddr **:**:**:**:**:**
done
Setup mac address.
read_key 0
done
Hit any key to stop autoboot: 0
(Re)start USB...
USB: scanning bus for devices... 3 USB Device(s) found
scanning bus for storage devices... 1 Storage Device(s) found
reading uImage
.................................................. .............................. .................................................. .............................. .................................................. .............................. .................................................. ......

3040766 bytes read
## Booting image at 80000000 ...
Image Name: Linux-2.6.32.61_stm24_0213
Image Type: SuperH Linux Kernel Image (gzip compressed)
Data Size: 3040702 Bytes = 2.9 MiB
Load Address: 80801000
Entry Point: 80802000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK

Starting kernel console=ttyAS0,115200 panic=1 ubi.mtd=3 root=ubi0:rootfs rootfst ype=ubifs rw coprocessor_mem=4m@0x40000000,4m@0x40400000 - 0x00000000 - 0 ...