Archiv verlassen und diese Seite im Standarddesign anzeigen : Loop through not working after standby!!
I have a receiver connected loop through from my HDMU one. Once I put my HDMU in standby (not deep), Signal is lost completely in loop through.
Is there anyway to keep lnb on during normal standby in HDMU??
Tell us which Box you are using.
Use a master slave sat switch, that's better than loop through.
My box is Octagon 1008P SE+. Once my HDMU goes to soft standby,no signal from lnb-out (It was working normally with Octagon firmware)
Use Deepstandby or a master slave sat switch
Thanks Santa for your reply. Unfortunately, It's not working also with deep standby. I noticed also that it only works well during HDMU booting, but once the image start loading the signal disappears.
I will try to get a sat switch but in my opinion there should be a way to keep lnb on during standby if this is the cause of the problem.
I made it a year ago with my UFS 913 for a short time, only for some tests, and it only worked with deep standby. I think in normal standby the tuner is still working, so you can't loop through.
Powered by vBulletin® Version 4.2.5 Copyright ©2024 Adduco Digital e.K. und vBulletin Solutions, Inc. Alle Rechte vorbehalten.