Hi,
danke morly, dass du dich um sh4 kümmerst.
Der Topf bleibt bei LOAD MODULES stehen.
Hier das log beim Startversuch:
Code:
ToFiÿ
<<< Loader L23231>>>
“ToFi"Z¿Š¿Z[!p

Board: TF7700  [29-bit mode]



U-Boot 1.3.1-gfeb9b4b7-dirty (Oct 23 2011 - 12:43:54) - stm23_0043

DRAM:  128 MiB
NOR:     8 MiB
In:    serial
Out:   serial
Err:   serial
Hit any key to stop autoboot:  1  0 
(Re)start USB...
USB:   scanning bus for devices... 1 USB Device(s) found
       scanning bus for storage devices... 0 Storage Device(s) found
** Can't read from device 0 **

** Unable to use usb 0:1 for fatload **
## Booting image at 85000000 ...
Bad Magic Number
## Booting image at 80060000 ...
   Image Name:   Linux-2.6.32.71_stm24_0217
   Image Type:   SuperH Linux Kernel Image (gzip compressed)
   Data Size:    1961528 Bytes =   1.9 MiB
   Load Address: 84001000
   Entry Point:  84002000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK

Starting kernel console=ttyAS0,115200 root=/dev/sda1 rw init=/bin/devinit ip=192.168.178.100:::255.255.255.0:tf7700:eth0:off mem=128m coprocessor_mem=4m@0x10000000,4m@0x10400000 rootdelay=6 nwhwconf=device:eth0,hwaddr:00:3e:9e:53:7d:9e - 0x00000000 - 0 ...


INIT: version 2.88 booting

init frontpanel
fsck.jfs version 1.1.15, 04-Mar-2011
processing started: 1/22/2018 15:43:12
The current device is:  /dev/sda3

The superblock does not describe a correct jfs file system.

If device /dev/sda3 is valid and contains a jfs file system,
then both the primary and secondary superblocks are corrupt
and cannot be repaired, and fsck cannot continue.

Otherwise, make sure the entered device /dev/sda3 is correct.

[mountvirtfs] Mount /dev in tmpfs
[mountvirtfs] Copying device nodes to /dev
Starting portmap daemon....
Loading autofs
Starting autofs
[mountall] Mounting local filesystems...
Cleaning /tmp.
Hostname: TOPF.
init stmfb
LOADING MODULES
load firmware
copLoadFile (file /boot/audio.elf)
error ReadBytes
copLoadFile (file /boot/video.elf)
ustslave: Kernel Version: 24
base_address 0x10000000
init embx
Hier noch das gesamte Log von der 2. Instalation bis Ende das Startvesuchs:
Code:
ToFiÿ <<< Loader L23231>>>
 “ToFi"Z¿Š¿Z[!p
 

 Board: TF7700  [29-bit mode]
 

 

 

 U-Boot 1.3.1-gfeb9b4b7-dirty (Oct 23 2011 - 12:43:54) - stm23_0043
 

 DRAM:  128 MiB
 NOR:     8 MiB
 In:    serial
 Out:   serial
 Err:   serial
 Hit any key to stop autoboot:  1  0 
 (Re)start USB...
 USB:   scanning bus for devices... 2 USB Device(s) found
        scanning bus for storage devices... 1 Storage Device(s) found
 reading uImage
 ............................................................................................................................................................................................................................................................................................................................................................................................................................
 

 

 

 4224608 bytes read
 ## Booting image at 85000000 ...
    Image Name:   Linux-2.6.32.28_stm24_0207
    Image Type:   SuperH Linux Kernel Image (gzip compressed)
    Data Size:    4224544 Bytes =   4 MiB
    Load Address: 84001000
    Entry Point:  84002000
    Verifying Checksum ... OK
    Uncompressing Kernel Image ... OK
 

 Starting kernel console=ttyAS0,115200 root=/dev/sda1 rw init=/bin/devinit ip=192.168.178.100:::255.255.255.0:tf7700:eth0:off mem=128m coprocessor_mem=4m@0x10000000,4m@0x10400000 rootdelay=6 nwhwconf=device:eth0,hwaddr:00:3e:9e:53:7d:9e - 0x00000000 - 0 ...
 

 115200
 speed 115200 baud;
 intr = ^C; quit = ^\; erase = ^?; kill = ^U; eof = ^D; eol = <undef>;
 eol2 = <undef>; start = ^Q; stop = ^S; susp = ^Z; rprnt = ^R; werase = ^W;
 lnext = ^V; flush = ^O; min = 1; time = 0;
 -brkint ixoff -imaxbel
 -------------------------------------
 deploy.sh
 V0.10: Try several times to mount USB sticks if mount fails
 V0.09: Log installation to boot medium removed again because it caused problems
 V0.08: Log installation to boot medium
 V0.07: Do not install E2 if disk is not partitioned
              and parameter partition is set to 0
 V0.06: Added EXT2 option for E2 and MINI partitions
 V0.05: Added JFS option for RECORD partition
 V0.04: Changed ini File format
 V0.03: Suppress meaningless tar errors during save settings
 V0.02: Format Mini partitions with Ext3 instead of Ext2
 V0.01: New parameter CREATEMINI and cleanup of KEEPSETTINGS
 -------------------------------------
 Mounting USB stick
 Specification for KEEP SETTINGS detected at line 67
 Specification for additional KEEP SETTINGS detected at line 88
 -------------------------------------
 partition: 0
 createmini: 0
 keepsettings: 0
 keepbootargs: 1
 usejfs: 1
 useext2e2: 0
 usbhdd: 0
 format: 1
 update: 1
 -------------------------------------
 Skipping partitioning of the disk
 OK, Disk already partitioned.
 Formatting HDD
 mke2fs 1.41.14 (22-Dec-2010)
 Filesystem label=MINI9
 OS type: Linux
 Block size=4096 (log=2)
 Fragment size=4096 (log=2)
 Stride=0 blocks, Stripe width=0 blocks
 131648 inodes, 526128 blocks
 26306 blocks (5.00%) reserved for the super user
 First data block=0
 Maximum filesystem blocks=541065216
 17 block groups
 32768 blocks per group, 32768 fragments per group
 7744 inodes per group
 Superblock backups stored on blocks: 
     32768, 98304, 163840, 229376, 294912
 

 Writing inode tables:  0/17 1/17 2/17 3/17 4/17 5/17 6/17 7/17 8/17 9/1710/1711/1712/1713/1714/1715/1716/17done                            
 Creating journal (16384 blocks): done
 Writing superblocks and filesystem accounting information: done
 

 This filesystem will be automatically checked every 24 mounts or
 180 days, whichever comes first.  Use tune2fs -c or -i to override.
 Setting up swapspace version 1, size = 271430144 bytes
 8+0 records in
 8+0 records out
 Installing root file system
 Flashing U-Boot settings
 186+1 records in
 186+1 records out
 Skipped flashing mtdblock2 on user request.
 Flashing kernel
 3831+1 records in
 3831+1 records out
 e2fsck 1.41.14 (22-Dec-2010)
 Pass 1: Checking inodes, blocks, and sizes
 Pass 2: Checking directory structure
 Pass 3: Checking directory connectivity
 Pass 4: Checking reference counts
 Pass 5: Checking group summary information
 MINI9: 5312/131648 files (7.0% non-contiguous), 54498/526128 blocks
 swapoff: /etc/fstab: No such file or directory
 

 The system is going down NOW
 

 Sending SIGTERM to all processe
 

 Sending SIGKILL to all processe
 

 Requesting system reboo
 ToFiÿ
 <<< Loader L23231>>>
 “ToFi"Z¿Š¿Z[!p
 

 Board: TF7700  [29-bit mode]
 

 

 

 U-Boot 1.3.1-gfeb9b4b7-dirty (Oct 23 2011 - 12:43:54) - stm23_0043
 

 DRAM:  128 MiB
 NOR:     8 MiB
 In:    serial
 Out:   serial
 Err:   serial
 Hit any key to stop autoboot:  1  0 
 (Re)start USB...
 USB:   scanning bus for devices... 2 USB Device(s) found
        scanning bus for storage devices... 1 Storage Device(s) found
 reading uImage
 

 

 ** Unable to read "uImage" from usb 0:1 **
 ## Booting image at 85000000 ...
 Bad Magic Number
 ## Booting image at 80060000 ...
    Image Name:   Linux-2.6.32.71_stm24_0217
    Image Type:   SuperH Linux Kernel Image (gzip compressed)
    Data Size:    1961528 Bytes =   1.9 MiB
    Load Address: 84001000
    Entry Point:  84002000
    Verifying Checksum ... OK
    Uncompressing Kernel Image ... OK
 

 Starting kernel console=ttyAS0,115200 root=/dev/sda1 rw init=/bin/devinit ip=192.168.178.100:::255.255.255.0:tf7700:eth0:off mem=128m coprocessor_mem=4m@0x10000000,4m@0x10400000 rootdelay=6 nwhwconf=device:eth0,hwaddr:00:3e:9e:53:7d:9e - 0x00000000 - 0 ...
 

 

 INIT: version 2.88 booting
 

 init frontpanel
 skip
 fsck.jfs version 1.1.15, 04-Mar-2011
 processing started: 1/22/2018 15:52:13
 

 Error: Cannot open device /dev/sda3
 

 Usage:  fsck.jfs [-afnpvV] [-j journal_device] [--omit_journal_replay] [--replay_journal_only] device
 

 Emergency help:
  -a                 Automatic repair.
  -f                 Force check even if file system is marked clean.
  -j journal_device  Specify external journal device.
  -n                 Check read only, make no changes to the file system.
  -p                 Automatic repair.
  -v                 Be verbose.
  -V                 Print version information only.
  --omit_journal_replay    Omit transaction log replay.
  --replay_journal_only    Only replay the transaction log.
 [mountvirtfs] Seems to be the first run - Making devices in /dev...
 [makedev] Starting makedev...
  CI-slot(s) : Yes
  Tuners     : 2
  HDMI CEC   : No
 [makedev] done.
 [mountvirtfs] Mount /dev in tmpfs
 [mountvirtfs] Copying device nodes to /dev
 Starting portmap daemon....
 Loading autofs
 Starting autofs
 [mountall] Mounting local filesystems...
 Cleaning /tmp /var/run /var/lock.
 Hostname: TOPF.
 init stmfb
 LOADING MODULES
 load firmware
 copLoadFile (file /boot/audio.elf)
 error ReadBytes

 copLoadFile (file /boot/video.elf)
 ustslave: Kernel Version: 24
 base_address 0x10000000
 init embx