What usb stick can you use for HDMU

[morly]

OK - after re-creating the partition table you have to re-partition the stick,
change the number of parts - everything gets yellow - change all your settings and confirm with the green tick (button)

this will take some time - then try the first given command again - any changes?

[rron]

I will give it a try this week. I shall report it here. Than
k you

[rron]

OK - after re-creating the partition table you have to re-partition the stick,
change the number of parts - everything gets yellow - change all your settings and confirm with the green tick (button)

this will take some time - then try the first given command again - any changes?

I did this procedure but the after that i tried to mount again and still no success

I used again these commands: fdisk -l, blkid, mount and this was the result:

[PGI ~]$ fdisk -l

Disk /dev/sda: 750.1 GB, 750156374016 bytes
255 heads, 63 sectors/track, 91201 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes

Device Boot Start End Blocks Id System

Disk /dev/sdb: 7817 MB, 7817125376 bytes
241 heads, 62 sectors/track, 1021 cylinders
Units = cylinders of 14942 * 512 = 7650304 bytes

Device Boot Start End Blocks Id System

[PGI ~]$ blkid
/dev/mtdblock3: TYPE="squashfs"
/dev/sdb: UUID="ACC8-98A4" TYPE="vfat"

[PGI ~]$ mount
rootfs on / type rootfs (rw)
/dev/root on / type squashfs (ro)
none on /dev type tmpfs (rw)
none on /tmp type tmpfs (rw)
proc on /proc type proc (rw)
sysfs on /sys type sysfs (rw)
usbfs on /proc/bus/usb type usbfs (rw)
devpts on /dev/pts type devpts (rw)
tmpfs on /dev/shm type tmpfs (rw)
/dev/mtdblock4 on /var type jffs2 (rw,noatime)
none on /mnt type tmpfs (rw)

- - - Aktualisiert - - -

I did a reboot and now I can mount!!
Thx for all the good advise