Hi everybody,
I've an ipbox9000 and i would like to try a hdmu image.
Actually I've installed a AAF E2 on flash.
Is there any step by step tutorial or can someone guide me how to get hdmu on my box?
Thanks.
Hi everybody,
I've an ipbox9000 and i would like to try a hdmu image.
Actually I've installed a AAF E2 on flash.
Is there any step by step tutorial or can someone guide me how to get hdmu on my box?
Thanks.
No, no. No hard disk installed. But maybe i can find one if is necessary.
Then i will install a hdd.
What's the first step after hdd is installed?
you have to create some partitions.
1 RECORD in ext3
2 SWAP
3 MINI1 in ext2
4 MINI2 in ext2
swap and minis should be 500MB, the other GBs for RECORD
do you know how to create parts?
I don't know how to create partition. I'm familiar with putty and winscp.
Can you pass me commands to make parts?
Half tera for every partition? Is not to much? A black hole image for vu+ is less than 200mb. Can't believe it!
So recommended pen or hdd is 2Tb?
I run the image off a pen drive without too many issues!
If you have multi boot all is good...
This is how I created my pen drive boot.
I assume you have e2 in flash
You will need to be able to FTP your box, and use putty...
I use putty for the next bit.
User: root
Password: HDMU
To create a partition on the pen drive
mkfs,ext2 /dev/sdb1 -L ext2
Then copy your downloaded file into this directory via FTP transfer (tar.gz on this site)
Back to putty...to unpack the file
mount dev sdb1 /mnt/usb
Then use putty to unpack the file...
cd /mnt/usb
tar -vzxf *****.tar.gz (then the full name of the image)
then...
sync
remove the image using FTP if required.
Start your box using the correct key number on the remote. Set-up the image as per the instructions
Cheers