Hdmu and ipbox9000

[santa]

shutdown

key power, then hold key number 3 until ide-sda3 is to read in your vfd.

now hdmu should boot.

configure your image, then:

mkfs.ext4 -L RECORD /dev/sda1

reboot, have fun

[blaska]

Ok Santa, we'll do the final step tomorror.
Thanks alot!
Tomorrow I'll post results.

[blaska]

Are you sure is number 3 on the remote control?
I've found this:
1) boot from cdkroot
2) boot from USB with hdd
3) original images
4) boot from release
5) boot from USB without hdd
6) boot from SATA hdd
7) boot from flash

[santa]

Yes, because fw_setenv sets New bootsrgs, and we prepare key 3 and 4

[blaska]

Sda2-usb and nothing on tv screen.

[blaska]

If i hold on number 4 on tv control, vfd shows sda3-IDE but doesn't boot and black screen on tv.

[santa]

You have to use fw_setenv like in post 39 before you can Boot from that.

[blaska]

I don't understand what i must do with all that data (fw_setenv...) should i put it with putty? Everything?

- - - Aktualisiert - - -

Is this way?

AAF-ipbox9000:~# fw_setenv menu_3 'setenv bootide "run bootargside;ide reset;ext
2load ide 0:3 a5ff0000 boot/uImage;bootm a5ff0000";setenv bootargside "setenv bo
otargs console=ttyAS1,115200 root=/dev/sda3 rw init=/bin/devinit ip=$ipaddr:$ser
verip:$gateway:$netmask:cuberevo:eth0ff mem=128m coprocessor_mem=4m@0x10000000
,4m@0x10400000 rootdelay=0 nwhwconf=device:eth0,hwaddr:$ethaddr";setenv bootcmd
"run bootide";saveenv;front_puts SDA3-IDE;boot'
Unlocking flash...
Done
Erasing old environment...
Done
Writing environment to /dev/mtd1...
Done
Locking ...
Done
AAF-ipbox9000:~#
AAF-ipbox9000:~#
AAF-ipbox9000:~# fw_setenv menu_4 'setenv bootide "run bootargside;ide reset;ext2load ide 0:4 a5ff0000 boot/uImage;bootm a5ff0000";set
env bootargside "setenv bootargs console=ttyAS1,115200 root=/dev/sda4 rw init=/bin/devinit ip=$ipaddr:$serverip:$gateway:$netmask:cube
revo:eth0ff mem=128m coprocessor_mem=4m@0x10000000,4m@0x10400000 rootdelay=0 nwhwconf=device:eth0,hwaddr:$ethaddr";setenv bootcmd "r
un bootide";saveenv;front_puts SDA4-IDE;boot'
Unlocking flash...
Done
Erasing old environment...
Done
Writing environment to /dev/mtd1...
Done
Locking ...
Done

- - - Aktualisiert - - -

Done! finaly! its working!
You've been so kind! thank you so much!
Which softcam do you recomend for cccam connection as a client?

[santa]

Sorry we don't Support sharing.

[blaska]

It's my own server, i share with myself. Anyway, I respect your rules.
Thanx again.