HDMU for Openbox S7 ?

[clown]

Hello,
wich version of HDMU i can use for OpenBox S7 .. (HD-BOX FS-9200) ?

I have installed generic USB HDMU HDMU_11940_E2_hdbox_209_git_5580_nodebug_mix_USB.t ar, but my reciever often freeze (HDMU logo dance).
Mainly STB freeze when i want to see EPG and scroll up / down. After cca 5 seconds channel preview freeze, and i can't do anything else. OK .. i can forget to use EPG.

If i leave STB unattended for few hours (powered on) and come back, it somehow stop to switch between channels, when i press MENU key, HDMU logo appears and "dance" on left corner.

But everytime is STB accessible via tlenet / ssh.
Installed modules are still accessible via web if
Uptime says correct times and cca 14 - 16% of CPU usage whole time.

So only reboot via console or HW switch help me.

Do somebody have any idea ? Is there so debug tool ?
many thanks

Tomas

[santa]

no support for cs, please delete it in your post.

enable swap

[clown]

SWAP enabled ..,
on SD channels runs and decode for one day/night without problem. When i turn to NGC HD, or DISCOVERY HD (both in Dolby Digital) it once freeze completly .. (no response to ping), once only stop do display signals. .. web if / telnet stay accessible.
Is there some tool to watch a CPU temp ? Because free -m command shows cca 22MB free of RAM.
But one thing .. , a TOP command i can see NIC parameter at 98% and more. What this parameter means ?

Is there some memory test / stress tool ? I think about some HW fault.

many thanks

[morly]

try the following:

cat /proc/kmsg

any "Hardware Error"?

[clown]

Yes,
maybe HW problem. Now i was put a CPU fan on the top of CPU heatsink. We will see,
next steps will be complete removal of heatsink and some "tuning" of cooling system. And also i can try run on my Irdeto card