[HELP]: Wrong u_boot into flash

[harryhase]

Octagon SF-918G SE+ Difference:270100A0

Do you have tried to flash a 918g image? i'm wondering why the image didn't start?

some environment are diffrent to my 918g, but i can't see a real problem, but you can try (without save !!!)

set board "hdk7111_INPUT_CLOCK_RATE"
set targetname "muso"
set bootcmd "nand read.jffs2  0x80000000 0x00500000 0x00300000; bootm  0x80000000"
set hwnfconf "setenv nwhwnet device:eth0,hwaddr:$ethaddr"
set ipconf "setenv ipaddrcfg ip "$ipaddr:$serverip:$gateway:$netmask:sdk:eth0:off"
set updt_all "nand erase clean;vfd updt_ker;updt_img"
set updt_boot "vfd LD;tftp 0x80000000 u-boot.bin;nand erase 0x00000000 0x00040000;nand write.jffs2 0x80000000 0x00000000 $filesize;vfd _End"
set updt_ker "vfd LD;tftp 0x80000000 vmlinux.ub.cram;nand erase 0x00500000 0x00300000;nand write.jffs2 0x80000000 0x00500000 $filesize;vfd _End"
set updt_img "vfd LD;tftp 0x80000000 root_ubi.img;nand erase 0x00800000 0x6000000;nand write.jffs2 0x80000000 0x00800000 $filesize;vfd _End"
set erase_config "nand erase 0x00400000 0x00100000"
set erase_eeprom "mw.b 80000000 ff 1000;eeprom_i2c write 0x80000000 0 0x001000"
set erase_env "nand erase 0x060000 0x20000"
set stdin "serial"
set stdout "serial"
set stderr "serial"

boot