Loop through not working after standby!!

[tanaka]

I have a receiver connected loop through from my HDMU one. Once I put my HDMU in standby (not deep), Signal is lost completely in loop through.

Is there anyway to keep lnb on during normal standby in HDMU??

[ReWard]

Tell us which Box you are using.

[santa]

Use a master slave sat switch, that's better than loop through.

[tanaka]

My box is Octagon 1008P SE+. Once my HDMU goes to soft standby,no signal from lnb-out (It was working normally with Octagon firmware)

[santa]

Use Deepstandby or a master slave sat switch

[tanaka]

Thanks Santa for your reply. Unfortunately, It's not working also with deep standby. I noticed also that it only works well during HDMU booting, but once the image start loading the signal disappears.

I will try to get a sat switch but in my opinion there should be a way to keep lnb on during standby if this is the cause of the problem.

[ReWard]

I made it a year ago with my UFS 913 for a short time, only for some tests, and it only worked with deep standby. I think in normal standby the tuner is still working, so you can't loop through.