Tried to get a log via serial but no matter what image is installed it only gives the Kernel details and some other info as below;
Board: STx7105-PDK [32-bit mode]
U-Boot 1.3.1 (Jun 19 2012 - 17:10:44) - stm23_0051 - YW_1.1.005 overclock
DRAM: 256 MiB
Panel: VFD
NAND: Bad block table found at page 262080, version 0x01
Bad block table found at page 262016, version 0x01
512 MiB
SPI: info: found AT25DF161 (2MiB) device (page=256,erase=65536)
warning: SPI device may be write-protected (status=0x0c)
In: serial
Out: serial
Err: serial
Ident ic exist
Ident ic get stb id
IdentID : 0c 00 0a 00 00 15 d3
Hit ESC to stop autoboot: 0
Loading from NAND 512MiB 3,3V 8-bit, offset 0x18000000
Image Name: Linux-2.6.32.28_stm24_0207
Image Type: SuperH Linux Kernel Image (gzip compressed)
Data Size: 2693637 Bytes = 2.6 MiB
Load Address: 80801000
Entry Point: 80802000
## Booting image at 80000000 ...
Image Name: Linux-2.6.32.28_stm24_0207
Image Type: SuperH Linux Kernel Image (gzip compressed)
Data Size: 2693637 Bytes = 2.6 MiB
Load Address: 80801000
Entry Point: 80802000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
stmac_phy_get_addr(): id1 = 0xffff, id2 = 0xffff
found phy at addres = 2
stmac_phy_get_addr(): id1 = 0x7, id2 = 0xc0f1
stb_id = c0a0015d3
Starting kernel console=ttyAS1,115200 rw root=/dev/mtdblock6 rootfstype=jffs2 init=/bin/devinit coprocessor_mem=4m@0x40000000,4m@0x40400000 printk=1 ip=172.100.100.249:172.100.100.174:172.100.100.174 :255.255.0.0:Enigma2:eth0:off stmmaceth=msglvl:0,phyaddr:2,watchdog:5000 bigphysarea=6000 nwhwconf=device:eth0,hwaddr00:0A:00D3 Manufacture=Spark-Project STB_ID=0C:00:0A:00:00D3 - 0x00000000 - 0 ...