Zitat Zitat von samkooke Beitrag anzeigen
my problem is 7119 blocked on 7119 and flashes red
From this I grasp the display shows 7119 immediately after power on, combined with a blinking red LED. First of all, the original boot loader cannot
display the text 7119, not even a broken one (it should display L7.00, L7.06 or L7.07). The blinking red LED shows there is some code executing and that the loader cannot find an image anywhere. It is highly probable that the boot loader is just fine.

That leaves two options:
1.NAND flash memory has a hardware failure
2.There is no valid image in flash and the receiver cannot read your USB stick properly (or the image on the stick is corrupt).

Try this:
Power the receiver off by pulling the DC plug on the back. Press and hold channel down on the receivers front panel and insert the DC power plug again. Keep holding the front panel key until the display shows OFF, then release it.

Flash a factory image using the channel up procedure. After a restart this should yield a running stock firmware with steady green LED. If it does, consider using another USB stick. Not all sticks work well; the receiver is rather particular in this respect.

Regards,

Audioniek.