Klinke mich mal mit ein zum Flashproblem, hier mal der Log Ausschnitt wo der Pingulux aussteigt.
Im Anhang mal ein paar Sachen die von mir getestet wurden, wenn auch mit 209, was jedoch hierbei nicht relevant sein sollte, und als stabil für Spark zu sehen sind.
Ich stelle das gerne zum testen zur Verfügung im geistigen Sinne der transparenten Entwicklung.

Code:
input: fulan front panel buttons as /devices/virtual/input/input1
scsi 0:0:0:0: Direct-Access     takeMS   USB Easy II      8.07 PQ: 0 ANSI: 2
sd 0:0:0:0: [sda] 8221696 512-byte logical blocks: (4.20 GB/3.91 GiB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Assuming drive cache: write through
sd 0:0:0:0: [sda] Assuming drive cache: write through
 sda: sda1
sd 0:0:0:0: [sda] Assuming drive cache: write through
sd 0:0:0:0: [sda] Attached SCSI removable disk
stmcore-display: using HDMI hotplug
stmcore-display: STi7111 display probed
device probe found 2 display pipelines
requesting frm: 'component.fw', c11fe184/875a3890
 stm-awg: firmware: requesting component.fw
loading frm: 'component.fw' failed: -2
requesting frm: 'fdvo0.fw', c11fe184/875a3a10
 stm-awg: firmware: requesting fdvo0.fw
loading frm: 'fdvo0.fw' failed: -2
stmfb: fb0 parameters = "1280x720-32@50:15m:10m:pal:yuv:yuv"
trying to alloc 10485760 bytes (align: 0000, still needed: 10485760) from 'gfx-memory' for GFX0 auxmem
success: base: 4a000000, still needed: 0
stmfb: Starting HDMI Output hdmi = 875e0000
stmfb: fb1 parameters = "<NULL>"