Guten Morgen
I have an issue at present ... image compiles all ok but when i install it and boot it hangs on boot ....
As i say the image compiles ok using Spark7162 and 0211
The log is as follows;
Code:Board: STx7105-PDK [32-bit mode] U-Boot 1.3.1 (Jun 19 2012 - 17:10:44) - stm23_0051 - YW_1.1.005 overclock DRAM: 256 MiB Panel: VFD NAND: Bad block table found at page 262080, version 0x01 Bad block table found at page 262016, version 0x01 512 MiB SPI: info: found AT25DF161 (2MiB) device (page=256,erase=65536) warning: SPI device may be write-protected (status=0x0c) In: serial Out: serial Err: serial Ident ic exist Ident ic get stb id IdentID : 0c 00 0a 00 00 15 c6 Hit ESC to stop autoboot: 0 Loading from NAND 512MiB 3,3V 8-bit, offset 0x18000000 Image Name: Linux-2.6.32.59_stm24_0211 Image Type: SuperH Linux Kernel Image (gzip compressed) Data Size: 2565491 Bytes = 2.4 MiB Load Address: 80801000 Entry Point: 80802000 ## Booting image at 80000000 ... Image Name: Linux-2.6.32.59_stm24_0211 Image Type: SuperH Linux Kernel Image (gzip compressed) Data Size: 2565491 Bytes = 2.4 MiB Load Address: 80801000 Entry Point: 80802000 Verifying Checksum ... OK Uncompressing Kernel Image ... OK stmac_phy_get_addr(): id1 = 0xffff, id2 = 0xffff found phy at addres = 2 stmac_phy_get_addr(): id1 = 0x7, id2 = 0xc0f1 stb_id = c0a0015c6 Starting kernel console=ttyAS0,115200 rw root=/dev/mtdblock6 rootfstype=jffs2 init=/bin/devinit coprocessor_mem=4m@0x40000000,4m@0x40400000 printk=1 ip=172.100.100.249:172.100.100.174:172.100.100.174:255.255.0.0:Enigma2:eth0:off stmmaceth=msglvl:0,phyaddr:2,watchdog:5000 bigphysarea=6000 nwhwconf=device:eth0,hwaddr:30:00:0A:00:15:C6 Manufacture=Spark-Project STB_ID=0C:00:0A:00:00:15:C6 - 0x00000000 - 0 ... Linux version 2.6.32.59_stm24_0211 (user@ubuntu) (gcc version 4.5.2 20110124 (STMicroelectronics/Linux Base 4.5.2-78) (GCC) ) #1 PREEMPT Thu Nov 15 15:26:12 EST 2012 Boot params: ... MOUNT_ROOT_RDONLY - 00000001 ... RAMDISK_FLAGS - 00000000 ... ORIG_ROOT_DEV - 00000200 ... LOADER_TYPE - 00000000 ... INITRD_START - 00000000 ... INITRD_SIZE - 00000000 Booting machvec: hdk7105 Node 0: start_pfn = 0x40000, low = 0x50000 Zone PFN ranges: Normal 0x00040000 -> 0x00050000 Movable zone start PFN for each node early_node_map[1] active PFN ranges 0: 0x00040000 -> 0x00050000 STMicroelectronics HDK7105 board initialisation STx7105 version 4.x Built 1 zonelists in Zone order, mobility grouping on. Total pages: 65024 Kernel command line: console=ttyAS0,115200 rw root=/dev/mtdblock6 rootfstype=jffs2 init=/bin/devinit coprocessor_mem=4m@0x40000000,4m@0x40400000 printk=1 ip=172.100.100.249:172.100.100.174:172.100.100.174:255.255.0.0:Enigma2:eth0:off stmmaceth=msglvl:0,phyaddr:2,watchdog:5000 bigphysarea=6000 nwhwconf=device:eth0,hwaddr:30:00:0A:00:15:C6 Manufacture=Spark-Project STB_ID=0C:00:0A:00:00:15:C6 bpa2: partition 'bigphysarea' created at 0x40e95000, size 24000 kB (0x01770000 B) PID hash table entries: 1024 (order: 0, 4096 bytes) Dentry cache hash table entries: 32768 (order: 5, 131072 bytes) Inode-cache hash table entries: 16384 (order: 4, 65536 bytes) PVR=04909200 CVR=60880000 PRR=00009e40 I-cache : n_ways=2 n_sets=512 way_incr=16384 I-cache : entry_mask=0x00003fe0 alias_mask=0x00003000 n_aliases=4 D-cache : n_ways=2 n_sets=512 way_incr=16384 D-cache : entry_mask=0x00003fe0 alias_mask=0x00003000 n_aliases=4 Memory: 222848k/262144k available (3360k kernel code, 1045k data, 136k init) SLUB: Genslabs=11, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 Hierarchical RCU implementation. NR_IRQS:600 Failed to enable clk CLKA_REF, ignoring Failed to enable clk CLKA_PLL0LS, ignoring console [ttyAS0] enabled sh_tmu: TMU0 used for clock events sh_tmu: TMU0 used for periodic clock events sh_tmu: TMU1 used as clock source Calibrating delay loop... 538.62 BogoMIPS (lpj=1077248) Mount-cache hash table entries: 512 CPU: STx7105 NET: Registered protocol family 16 Configuring FLASH for boot-from-SPI bio: create slab <bio-0> at 0 SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb DMA: Registering DMA API. Switching to clocksource TMU1 NET: Registered protocol family 2 IP route cache hash table entries: 2048 (order: 1, 8192 bytes) TCP established hash table entries: 8192 (order: 4, 65536 bytes) TCP bind hash table entries: 8192 (order: 3, 32768 bytes) TCP: Hash tables configured (established 8192 bind 8192) TCP reno registered NET: Registered protocol family 1 RPC: Registered udp transport module. RPC: Registered tcp transport module. RPC: Registered tcp NFSv4.1 backchannel transport module. Installing knfsd (copyright (C) 1996 okir@monad.swb.de). Slow work thread pool: Starting up Slow work thread pool: Ready NTFS driver 2.1.29 [Flags: R/O]. JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc. fuse init (API version 7.13) JFS: nTxBlock = 1742, nTxLock = 13939 msgmni has been set to 435 io scheduler noop registered io scheduler anticipatory registered (default) lirc_dev: IR Remote Control driver registered, major 61 lirc-stm: probe found data for platform device lirc-stm lirc-stm: STM LIRC plugin using IRQ 125 in IR mode lirc_dev: lirc_register_driver: sample_rate: 0 STMicroelectronics LIRC driver initialized. STMicroelectronics ASC driver initialized stm-asc.0: ttyAS0 at MMIO 0xfd032000 (irq = 121) is a stm-asc stm-asc.1: ttyAS1 at MMIO 0xfd033000 (irq = 120) is a stm-asc loop: module loaded MiPHY driver style MiPHY3-65 probed successfully MiPHY3-65, c1.5 Claimed by sata-stm