goodmorning ;
@ solala
here is the output of command given above :
Code:7119 > print bootargs=console=ttyAS0,115200 panic=1 ubi.mtd=3 root=ubi0:rootfs rootfstype=ubifs rw coprocessor_mem=4m@0x40000000,4m@0x40400000 bootcmd=if usb reset; then run usbboot; fi; run mtdboot bootdelay=3 baudrate=115200 ipaddr=192.168.1.25 serverip=192.168.1.10 preboot=if ethaddr; then echo "Setup mac address."; else echo "Use default mac address.";fi ;bootmenu mtdboot=nand read.jffs2 0x80000000 0x00060000 0x00300000; bootm 0x80000000 usbboot=fatload usb 0:1 0x80000000 uImage; bootm 0x80000000 board=hdk7111 monitor_base=CFG_FLASH_BASE monitor_len=0x00040000 monitor_sec=1:0-4 load_addr=0x80000000 stdin=serial stdout=serial stderr=serial ethaddr=00:1e:b8:0a:ae:a3 update=00 Environment size: 675/131068 bytes 7119 >Spoiler:
Do you mean by anyfile.bin this one which size 256 KB ??
@ Audioniek ;Code:dev: size erasesize name mtd0: 00400000 00020000 "boot"
I tried with the .ird file , but the ch up doesn't work , because I think the u_boot into flash was made to load the E2 (kernel and the rootfs) which they are .img file . but even I use the usb_uboot.img given in the back folder I get no think ; this is the point . So I think the way is to write the appropiate file directly on the flash using the u_boot command line.
Regards