good evening what demo do you have?
good evening what demo do you have?
good evening ;
it's an hs7819 reseller ID 27 xx 20 A0
forever clone to xeobox 7200 id 271520A0 xeobox 270920A0.
Doing some research in stlinux site, I found this
Since the U_Boot variable "load_addr=0x80000000" , can I use these two commands as prescribed after the mtd0 file being loaded on RAM.For NAND Flash
In the case of NAND flash, the flash should be explicitly erased, prior to writing to it.
In the case of NAND, then most access operations need to be multiples of certain page/block sizes. For simplicity, the following code assumes that u-boot.bin fits in 256 KiB (0x40000). However, you may use smallest figures that are appropriately aligned.
Code:MB680> nfs $load_addr /export/u-boot.bin MB680> nand erase 0 40000 MB680> nand write $load_addr 0 40000
I'm trying doing my best , but still need help .
Regards
Geändert von kader_73 (22.04.2014 um 14:49 Uhr) Grund: spelling
hello again ;
still with my f*** machine, i tried to boot from usb as said in the help using usbboot command , mtd0 in root fat32
Code:7119 > usbboot 0x80000000 0:1 Loading from USB device 0, partition 1: Name: usbda1 Type: U-Boot ** Bad Magic Number ** 7119 >
Geändert von kader_73 (23.04.2014 um 16:33 Uhr)
please try and post output
Code:set bootcmd "nand read.jffs2 0x80000000 0x00500000 0x00300000; bootm 0x80000000" boot
hi harry,
was vermutest du am offset 0x500000? soll da in dem flashlayout der ursprünglichen firmware nen kernel liegen? obwohl ich die kiste nicht kenne wäre das sehr ungewöhnlich
Das sind die environment von meiner 7119; Irgendwas hat er ja sich ja geflasht und einen bootloader hat er ja auch;
Die Idee dahinter ist ein Image lauffähig zu bekommen; Dann den Reseller per plugin ändern; dann richtigen (definierten) Bootloader rein und ein Image wieder drüber braten.
Da ich nicht weiß welche resellerid er jetzt hat kann er weder Image noch bootloader drüber flashen.
Du hast bestimmt noch was anderes im Kopf?!