Sieht jetzt so aus:

Code:
Board: STb7200-HDBOX  [29-bit mode]




U-Boot 1.3.1 (Apr 28 2010 - 15:01:04) - stm23-0032
---created by TDT for general purpose---


DRAM:  128 MB
Flash:   32 MB
In:    serial
Out:   serial
Err:   serial
Frontpanel got PowerOn reset...
init Frontpanel... done, AV7000
Hit any key to stop autoboot:  1  0 
bootmenu_timeout:3000,default:3
add entry:0 - ---Flash---
add entry:1 - --USB1 P1--
add entry:2 - --USB1 P2--
add entry:3 - --USB1 P3--
add entry:4 - --USB1 P4--
add entry:5 - --USB2 P1--
add entry:6 - --USB2 P2--
add entry:7 - --USB2 P3--
add entry:8 - --USB2 P4--
add entry:9 - --USB 112--
entering bootmenu - default:3 - --USB1 P3--
selected: --USB1 P2--
USB:   scanning bus for devices... 3 USB Device(s) found
       scanning bus for storage devices... 1 Storage Device(s) found
reading /uImage2


** Unable to read "/uImage2" from usb 0:1 **
loading from usb 0:2


1898081 bytes read
## Booting image at a5000000 ...
   Image Name:   Linux-2.6.32.61_stm24_0215
   Image Type:   SuperH Linux Kernel Image (gzip compressed)
   Data Size:    1898017 Bytes =  1.8 MB
   Load Address: 84001000
   Entry Point:  84002000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK


Starting kernel console=ttyAS0,115200 nwhwconf=device:eth0,hwaddr:00:1E:B8:01:3C:0A ip=192.168.178.28::192.168.178.1:255.255.255.0:Twin:eth0:off root=/dev/sdb2 rw mem=128m coprocessor_mem=4m@0x10000000,4m@0x10400000 rootdelay=5 init=/bin/dev - 0x00000000 - 0 ...